9" HHD MUSCLEPAK 1968-72 GM A-Body (Chevelle)
9B6872CHV370
9" HHD MUSCLEPAK
FITS: 1968 1969 1970 1971 1972 GM A-BODY (Chevelle, Malibu, Cutlass, El Camino, etc...)
STOCK WIDTH
MOSER 31 SPLINE CUSTOM ALLOY AXLES
5 X 4 3/4" BOLT PATTERN - 1/2"-20 x 3" SCREW-IN STUDS
SEALED BALL AXLE BEARINGS (SKF)
3.062" PERFORMANCE NODULAR IRON CASE
31 SPLINE TRUETRAC LSD
1350 SERIES CHROME MOLY PINION YOKE (CONVERSION U-JOINT WILL BE REQUIRED WHEN USING STOCK DRIVESHAFT)
3.70:1 RATIO US GEAR RING & PINION
NODULAR IRON DAYTONA PINION SUPPORT
WILWOOD DYNALITE 12.19" DISC BRAKES W/PARKING BRAKE
RED CALIPERS
DRILLED & SLOTTED ROTORS
FILL & DRAIN PLUGS
HOUSING; POWDER COATED (MOSER RED POWDERCOAT)
CASE & PINION SUPPORT; POWDER COATED (BLACK SEMI-GLOSS)
COMPLETELY ASSEMBLED!
*MAY REQUIRE MODIFICATION TO STOCK DRIVESHAFT
UNIT WILL SHIP WITHIN 1-BUSINESS DAY OF COMPLETED TRANSACTION!
$5,688.00
$4,995.00
Complete 9" Ford MUSCLEPAK
THE STRONGER REAR-END REPLACEMENT!
All components are new manufactured items (No remanufactured, refurbished or rebuilt components).
Package includes; New HHD Moser 9" Made in the U.S.A. Housing, with OEM located mounting provisions, seamless steel tubing (3" O.D., 1/4" wall), custom alloy 31 spline bolt-in axles, bearings, studs, seals, heavy duty retainer plates, new housing ends, t-bolt kit, Trac-Loc clutch posi, "1310" Series pinion yoke, ring & pinion, set up with Timken bearings, New Drum Brakes, brake lines, brake line clamps, and emergency brake cables.
COMPLETELY ASSEMBLED!
All Musclepaks are assembled with the following Moser Engineering designed and manufactured in the USA components;
THE STRONGER REAR-END REPLACEMENT!
All components are new manufactured items (No remanufactured, refurbished or rebuilt components).
Package includes; New HHD Moser 9" Made in the U.S.A. Housing, with OEM located mounting provisions, seamless steel tubing (3" O.D., 1/4" wall), custom alloy 31 spline bolt-in axles, bearings, studs, seals, heavy duty retainer plates, new housing ends, t-bolt kit, Trac-Loc clutch posi, "1310" Series pinion yoke, ring & pinion, set up with Timken bearings, New Drum Brakes, brake lines, brake line clamps, and emergency brake cables.
COMPLETELY ASSEMBLED!
All Musclepaks are assembled with the following Moser Engineering designed and manufactured in the USA components;
- Housings
- Axles
- Cases
- Pinion Supports
- Pinion Yokes
- Spools
- Bearings & Seals
- Fasteners (all grade 8)
- Limited Slip Differentials
- Brake Components
- Ring & Pinions (Gears) - Moser Engineering does not manufacture any gears! These are sourced but not limited to the following suppliers; US Gear, Hoosier Gear, Motive/Richmond Gear & Yukon Gear
